We have worked with only the best shipbuilders to fulfill that request.It was the predecessor of the later Republic and Imperial models in the Star Destroyer line.Consequently, the Acclamator favored a wedge or dagger shaped design due to its effectivenessit allowed concentration of firepower while minimizing target profile.
![]() This basic design was used in a number of larger craft pre-dating it and would define Imperial ships for decades to come. This tower module was a standard design for smaller ships in Kuat Drive Yardss starship catalog, which Rothana supplied vessels to. The main bridge and command center had no windows but relied upon advanced holoscreens 1 shaped like the triangular viewports similar to the ones on other Kuat vessels. The bridge crew usually consisted of fully-armored clone pilots manning the control panels, 13 with most operators being seated in twin crew pits below the command officers area. Sensor and communications suites were located at the front of the ships command tower. They also carried eighty aircraft and eighty-four armored vehicles, such as the AT-TE and SPHA walkers, used to provide clone troopers with heavy battlefield support. In addition to ground landings, Acclamator -class ships were capable of water landings, as displayed at the Battle of Mon Calamari. Eighty Low Altitude Assault Transports, of which around 66 were infantry gunships and around 14 were vehicle carriers, were carried to insert personnel, vehicles, and cargo into battle zones in addition to providing close air support. Gunships were suspended along an overhead circulating rail in the upper hangar for maintenance procedures during travels. A lower, smaller hangar area was used to embark and disembark ground troops and material via a large ramp when landed. Armed with 4 heavy torpedo launch tubes; 24 point-defense cannons, rated at 6 megatons per shot; and 12 quad turbolaser turrets, each rated at a maximum of 200 gigatons per shot. The hull armor of Acclamator -class vessels was impregnated with ultra-dispersive neutronium that withstood and spread massive energy blasts. Fusion rockets fired by enemy forces barely made a scratch on the hull as a result. ![]() The tanks were connected to the main reactor via pipe assemblies. Secondary reactors were located towards the bow of the vessel. The secondary thrusters did not provide as much power, but were useful for maneuvering due to being placed further away from the ships main axis. Star Wars Acclamator Class Generator And TheThe massive fin at the stern of the Acclamator -class contained both the anti-gravity generator and the ships hyperdrive generator. When landed, the repulsorlift carried much of the ships weight, but the landing legs maintained a stable contact with the ground. The massive hyperdrive generator took up some two hundred meters of the ships length, and allowed a sustained hyperspace cruising speed of Class 0.6. After delivering their troops, the Acclamators pulled back to provide orbital support, with only a portion of the ships ending up damaged in the battle. All Acclamator s were completely crewed by clones, though they would also count regular Republic officers among their crews, as the war ground on. Apart from this, the Acclamator s and larger warships were generally off-limits to most regular defense force personnel. During the height of the war, some Acclamator s had the paint markings of the Open Circle Fleet like the Venators. For the Battle of Muunilinst, the assault ship Nevoota Bee was modified as a carrier, with her hangar decks dedicated to holding 156 V-19 Torrent starfighters. The Victory -class and other Star Destroyers were based on the Acclamator. The Empire never used the Acclamator in its fleets but did use them in planetary defense or skirmishes.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |